Skip to content

Select theme

Foamed surface

Gallery/Details

A pale printed surface filling the frame, with fine parallel layer lines and a faint speckle, and a dark printed sleeve on a carbon tube at the top edge., ivory colourway — The lightweight-PLA skin up close, on the port VTOL Section of Fuselage C v2.4B: 0.2 mm layer lines along the print axis and the speckle of foamed filament, with the PETG spar mount and the wire window at the Section's tip above (th-blender W83).

A pale printed surface filling the frame, with fine parallel layer lines and a faint speckle, and a dark printed sleeve on a carbon tube at the top edge., green colourway — The lightweight-PLA skin up close, on the port VTOL Section of Fuselage C v2.4B: 0.2 mm layer lines along the print axis and the speckle of foamed filament, with the PETG spar mount and the wire window at the Section's tip above (th-blender W83).

Series: Details
Engine: Cycles
Resolution: 2400 × 1500
Source: blender/renders/10-detail-lw-surface-cycles.png

Full size, green Full size, ivory

←PreviousVTOL motor mount NextVTOL Section→

More from details

CyclesPayload bay
CyclesHatch lifted
CyclesInside the nose
CyclesAntenna grommets

Comments

Comment on the whole page here, or on one section or step with the button beside it.

Comments on

No comments here yet.

Comments cannot load right now. Please try again later.

Name (optional)CommentWebsite

Comments are reviewed before they appear. Please leave out places, addresses and other personal details.

A Supported Systems Flight

This build log is written and kept by Supported Systems, a small studio that makes thoughtful, user-first technology. The airframe, the hangar and the simulation are ours.

Visit supported.systems