Skip to content
TerraHawkTerraHawk
Hold: do not print the aircraft (Ryan, 2026-10-10). The first build is Fuselage C v2.4B, and its beds wait for Ryan's go. Bench tools and test prints are exempt: they are not airframe parts, so they can print now (Ryan, 2026-10-11).

g14: Seals

Print jobs / First build

On hold: do not print this bed yet. All flight-part printing is held until Ryan releases the Fuselage C bed plan.

Light Battery Saddle (TPU) (C v2.4B, aft 8, lead forward) Fuselage C v2.4B Lucid Edge Gaskets (TPU) [print flat] Conduit Seal (C) (port) Conduit Seal (C) (starboard) Wire Window Cover (C v2.4B) (port) Wire Window Cover (C v2.4B) (starboard) Antenna Slot Grommet (port) Antenna Slot Grommet (starboard) Pusher Lead Grommet (TPU)
Top view to scale, 250 × 220 mm bed, 10 mm grid.

Parts

Point at a part to find it on the plan.

PartQtySourcePrinted from
Antenna Slot Grommet (port)1Ourssame
Antenna Slot Grommet (starboard)1Ourssame
Pusher Lead Grommet (TPU)1Ourssame
Wire Window Cover (C v2.4B) (port)1Ourssame
Wire Window Cover (C v2.4B) (starboard)1Ourssame
Light Battery Saddle (TPU) (C v2.4B, aft 8, lead forward)1Ourssame
Conduit Seal (C) (port)1Ourssame
Conduit Seal (C) (starboard)1Ourssame
Fuselage C v2.4B Lucid Edge Gaskets (TPU) [print flat]1Ourssame

Source: slicing/jobs/g14-tpu-seals.mdx, written by tools/print_jobs.py from tools/slice_all.py (g14-tpu-Seals).

Comments on

    Comments are reviewed before they appear. Please leave out places, addresses and other personal details.

    A Supported Systems Flight

    This build log is written and kept by Supported Systems, a small studio that makes thoughtful, user-first technology. The airframe, the hangar and the simulation are ours.

    Visit supported.systems