Skip to content
TerraHawkTerraHawk
Hold: do not print the aircraft (Ryan, 2026-10-10). The first build is Fuselage C v2.4B, and its beds wait for Ryan's go. Bench tools and test prints are exempt: they are not airframe parts, so they can print now (Ryan, 2026-10-11).

Wing halves, one piece, root to flat tip

Print jobs / Proposed

No plan: the geometry for this job is not made yet.

Parts

PartQtySourcePrinted from
Wing Inner + Wing Outer + Wing Tip (flat), one piece1Kit, modifiednone
Wing Inner + Wing Outer + Wing Tip (flat), one piecemirrored1Kit, modifiednone

What it would take

Footprint
about 300 x 35 mm each, standing on the root face
Glued joints it removes
  • Wing Inner to Wing Outer, x2
  • Wing Outer to tip, x2
Waits on
Each half stays detachable at its root quick-release plate. Waits on th-aeronautics' sealed-seam CFD and the design protocol (idea card docs/agent-threads/airframe-design/20260929T214524Z-th-main-wing-joint-idea.md).

Notes

Proposed for the 600 mm printer (2026-09-30). Not sliced: the geometry does not exist yet.

Source: slicing/jobs/p2-lw-wing-halves-one-piece.mdx.

Comments on

    Comments are reviewed before they appear. Please leave out places, addresses and other personal details.

    A Supported Systems Flight

    This build log is written and kept by Supported Systems, a small studio that makes thoughtful, user-first technology. The airframe, the hangar and the simulation are ours.

    Visit supported.systems